Cue relayCUE-8 Manuel d'utilisateur

User ManualrelayCUE-8Version 02CUE, a.s., K Nouzovu 6, 143 00 Praha 4, Czech Republic fax: +420 241 432 446www.cuesystem.commail: [email protected]

3.3...RS-232 port connectionThe controller ports capable only of RS-232 operation (like S1-S2 on ipCUE-al

3.4...IR/SERIAL port connectionIn some installation where the proper serial ports are not available and where th

4. Configuration4.1...Inserting relayCUE-8 into projectTo insert relayCUE-8 into your project, proceed as if inserting st

4.2...Setting relayCUE-8 propertiesAfter the relayCUE-8 has been properly inserted into your project, its properties

The properties are displayed in alphabetical order. The property value can be changed by selecting the property and then pressing button “Edit Propert

FilterFilter is time in range 0.01-0.20 sec. It means minimum time of closing/releasing the input contacts (pressing the button) for the press to b

5. ProgrammingWhen programming, you can proceed as in any other serial controller including drag and drop operations.The ava

Sub UnitByUnitIDIdentify (ByRef Status as String) This command serves mostly for testing and it is mainly to be used in debugging programs in large in

6. Exchange of relayCUE-8 in existing installationThere are two ways of replacing the relayCUE-8 unit in the existing installation:1. The best way of

7. Specifications and Mechanical DrawingsInputs...8 x digital (potential-free) contact closure input,.

User Manual relayCUE-8UM039_02, 14.04.2010Copyright © CUE, a.s., Praha, Czech Republic 1990 - 2010.All rights reserved. Specifications are subject to

8. Software and Firmware LicenseEND-USER NOTICE AND LICENSE AGREEMENT FROM CUE, a.s. NOTICE TO END-USER: CAREFULLY READ THE FOLLOWING LEG

Appendix A: Unit State String description“Unit State String" - current status of all parameters of the unit (lenght 90 bytes):byte 1 'i&apos

Appendix B: Cable CA0183 connectionNote:The 4P4C connector (popularly, but incorrectly, called RJ11, RJ10, or RJ9), is the de facto industry standard

NotesUser Manual relayCUE-8www.cuesystem.comPage 23 of 24

NotesUser Manual relayCUE-8www.cuesystem.comPage 24 of 24

Table of Contents Table of Contents...

1. Introduction1.1. Overview...The relayCUE-8 is an eight-channel relay switching unit

2. Front panelOn the front panel of relayCUE-8, there are the following indicators and buttons (from left to right):• PWR LED lighted on whenever the

Note several important points:• the process of displaying/changing Address and Bank using ACT button has no influence on current

3. ConnectingThe enclosure of relayCUE-8 allows simple installation into switchboard on DIN rail.3.1...Power, input and outpu

3.2....RS-485 port connectionThe relayCUE-8 control port is compatible with RS-485 standard

relayCUE-8 can also be connected via supplied cable CA0183 and PEbus cable adapter GP0045, see picture below. Other “Power Express”(PEX) units can als