Cue sensorCUE-W Manuel d'utilisateur

CUE, a.s., K Nouzovu 6, 143 00 Praha 4, Czech Republic fax: +420 241 432 446www.cuesystem.commail: [email protected]: +420 241 091 240 User

6. Program module for sensorCUE For easier programming you can use the module sensorCUE.csm. You can find it on the CUE Application CD in folder XPL

7. Specifications and Mechanical Drawings Temperature measurement...Range -20°C to +50°C Daylight sensing ...

8. Software and Firmware License END-USER NOTICE AND LICENSE AGREEMENT FROM CUE, a.s. NOTICE TO END-USER: CAREFULLY READ THE FOLLOWING LEGAL AGREEME

Notes User Manual sensorCUE-W www.cuesystem.com Page 13 of 14

User Manual sensorCUE-W www.cuesystem.com Page 14 of 14 Notes

User Manual sensorCUE-W UM034_01, 19.04.2008 Copyright © CUE, a.s., Praha, Czech Republic 1990 - 2008. All rights reserved. Specifications are subject

Table of Contents 1. Introduction...

1. Introduction 1.1. Overview... sensorCUE-W is a temperature and daylight sensor fo

2. Description The case of sensorCUE-W is a small plastic box (83 x 81 x 27 mm) which allows simple installation into the standard European electrica

3. Connecting The connection of sensorCUE-W is described in the picture below. Pin12Signal+24GDescriptionPower +24 VDCGroundPhoenix 4-pin 3.5 mm34A+B

4. Addressing Each unit connected to the CUEwire bus must have its unique address. These addresses for touchpanels and keyboards are set in configurat

5. Programming The standard command for reading out the data from sensorCUE-W is: RemoteVariableGet (reference as Word, paneladdress As Byte) as Word

Temperature –Response data relationship: TEMPERATURE RESPONSE VALUE (binary) RESPONSE VALUE (hex) +25.0625°C 0000 0001 1001 0001 0191H +10.125°C 000